|
|
1:
|
Universal Fuel Level Sensor Guide
(Technical Discussion & Questions - by MichiganReefer, started: 04-24-2023, last post: 2023-04-27 00:22:28 CEST)
Hey all, I've been working to restore my 88 GT and tried a little bit of fabrication to save myself a little bit of money. I was able to make a universal fuel level sender work for me and wanted to share with the rest of you. My particular fuel float arm assembly was reading 0 ohms regardless of...
Score: 775, Size: 48 bytes
|
2:
|
How to get the fuel sender level to be seen by the obdII
(Technical Discussion & Questions - by Tweeder, started: 05-27-2014, last post: 2022-09-21 16:55:50 CEST)
I have the ultra guage and in it for calculating the dte it would normally use the fuel sensor level but my vehicle doesn't support that in the obdII it says. So how do I get it to recognize it or do I have to wire it to certain pins in. The PCM? I see in the wiring swap diagram, it shows blue pin...
Score: 775, Size: 64 bytes
|
3:
|
Float for fuel level sending unit.
(Technical Discussion & Questions - by cmd88, started: 03-19-2021, last post: 2021-04-05 02:01:08 CEST)
If the float for the fuel level sending unit comes loose in the tank, can it be re-attached? I'd rather not drop the tank until the fuel pump goes bad, but an easy repair might motivate me.Anybody have good pics of the assembly?'88 coupe by the way.Thanks!cmd88[This message has been edited by...
Score: 775, Size: 40 bytes
|
4:
|
Floatless (tubular) Fuel Level Sending Unit.....A Panic Attack About to Commence
(Technical Discussion & Questions - by imacflier, started: 07-12-2020, last post: 2020-07-13 07:30:00 CEST)
Well, I plan on dropping my tank tomorrow and installing a floatless fuel sending unit. The unit I have (Note: not buying....HAVE) consists of a tube 1.5" in diameter by 10 " long. Going into an '88 GT. When measuring the zero ohms position, I get 0.197 ohms, the full position 89.973 ohms so it...
Score: 775, Size: 90 bytes
|
5:
|
Fuel Level Sender/Fuel Gauge Schematic?
(Technical Discussion & Questions - by imacflier, started: 06-22-2020, last post: 2020-06-26 04:10:09 CEST)
G'Morning, All,Well another day another question!I am looking for a schematic of the fuel sender/fuel gauge. Not a wiring diagram, but a schematic.I have searched the archives and on line, the FSM, and every other source I know of without any success.I know it is available because I recall seeing...
Score: 775, Size: 49 bytes
|
6:
|
fuel level gauge wire diagram
(Technical Discussion & Questions - by La fiera, started: 05-02-2019, last post: 2019-05-03 16:36:25 CEST)
Can anybody provide me with a wire diagram for the fuel level signal (pink) wire?I'm installing an aftermarket gauge and need to see where is the best place to get the signal from.Thanks!Rei
Score: 775, Size: 38 bytes
|
7:
|
need fuel level sending unit
(Technical Discussion & Questions - by dana sego, started: 01-14-2017, last post: 2018-09-08 16:14:55 CEST)
Where can I find a fuel sending unit that will replace my faulty unit and I did have the gas gauge tested OK?
Score: 775, Size: 38 bytes
|
8:
|
How To - Repair the Fuel Level Sending Unit
(Technical Discussion & Questions - by Xanth, started: 05-26-2008, last post: 2018-06-15 02:48:36 CEST)
I did this repair on mine today, and now my gauge went from running out of gas at 1/2 tank, to actually reading almost right on.Also available on FieroDomain: http://fierodomain.com/arti...ro-fuel-level-senderFirst step, drop the tank and pull the sending unit. Process on doing so is covered...
Score: 775, Size: 49 bytes
|
9:
|
Fuel level sending unit of '86 2.5?
(Technical Discussion & Questions - by Falstaff, started: 03-08-2018, last post: 2018-03-08 18:12:28 CET)
The fuel gauge, on my '86 2.5, only works until I hit 1/2 a tank and then it pegs the gauge full. I removed the tank and checked out the sending unit and it is indeed shot. I tried all of my regular parts suppliers and none of them can get a sending unit (a fuel pump would be no problem). I talked...
Score: 775, Size: 44 bytes
|
10:
|
fuel level sending unit
(Technical Discussion & Questions - by dana sego, started: 01-14-2017, last post: 2017-01-14 20:44:32 CET)
Thanks to tshark but my Fiero is a 4cyl. Lou6t4gto mentioned GM for 325 dollars, could you explain what GM is?
Score: 775, Size: 33 bytes
|
| |
|
Put a PFF Search Box on your Site!