|
|
141:
|
Engine Miss a year of fighting finally solved.
(Archive: TD&Q - by Capt Fiero, started: 02-22-2007, last post: 2009-02-19 10:46:08 CET)
Ok so my 4.9 had a mild miss about a year ago and over the past year it has came and gone, and recently got so bad that it was almost undrivable. If I matted the gas it would almost shut down, it was like flooding a carbed motor. Sustained speeds at really low throttle it would miss and buck...
Score: 633, Size: 59 bytes
|
142:
|
4.9 Eldorado Dual O2 adding O2 meter which O2 and Pin on ECM
(Archive: TD&Q - by Capt Fiero, started: 07-19-2005, last post: 2006-02-06 11:45:43 CET)
I am having some problems with my O2 meter on my car. First question is which connector and which pin should I hook my Dash Mounted O2 gauge to on the ECM.Second My scan tool says the O2 sensors are just reading 444mV and not really moving. However when I flip over to the lean rich flag area, it...
Score: 633, Size: 74 bytes
|
143:
|
Is this abnormally worn, Rotor and Cap 4.9 big pics inside
(Archive: TD&Q - by Capt Fiero, started: 03-14-2006, last post: 2006-08-11 13:07:25 CEST)
Does this look abnormally worn out to you. Also the center pin, isn't it suppose to have some sort of spring to it. It is solid and does not move. There is only a very small amount of the center pin the cap still protruding. My issue is the car has a serious miss especially under heavy...
Score: 633, Size: 71 bytes
|
144:
|
Update: Hot Rod 2.8 well not a 2.8 anymore.
(Archive: TD&Q - by Capt Fiero, started: 10-16-2000, last post: 2001-04-18 09:20:49 CEST)
Under recomendations of my local machine shop the engine has been bored out to 2.9 with chromoly rings and roller tip rockers. I have set up a web page with all the listed mods, the shop ran it through desktop dyno and came up with 190hp at 6000rpms and 192lbs of torqu at 4500rpms. But take a quick...
Score: 633, Size: 56 bytes
|
145:
|
So this why my clutch sounded like sandpaper
(Archive: TD&Q - by Capt Fiero, started: 05-10-2005, last post: 2006-02-06 11:46:14 CET)
For quite some time I had noticed what I thought to be my clutch throwout bearing dragging or input shaft bearing. On top of that, I had a serious case of clutch chatter. Well I am in the middle of a tear down to replace the entire trans axle and motor for a Caddy 4.9 and a 5spd. This is what I...
Score: 633, Size: 57 bytes
|
146:
|
My Brake Master is dying, ?? RE Blazer Master Cylnder upgrade
(Archive: TD&Q - by Capt Fiero, started: 07-22-2004, last post: 2005-01-19 11:12:28 CET)
I think my brake master cylnder is dying. I have found the resevior cap open 3 times. This is driving me nuts. I close it up solidly make sure all the clips are on tight and when I come out to check it a week or 2 later I find it un-latched again. The first time I thought it was just a fluke,...
Score: 633, Size: 74 bytes
|
147:
|
Automotive Higher Power Inverters for Fieros 110v @1.5kiliwatt output.
(Archive: TD&Q - by Capt Fiero, started: 07-24-2009, last post: 2011-05-02 10:44:13 CEST)
I have a 75w baby, that plugs into the lighter with 1 port, a 350w that should be hooked direct to the battery but will run at a reduced rate when plugged into the lighter socket. Now I have a big dawg, It runs up to 1.5 KW peak, and and 750 watt continuous. That should be good enough to power a...
Score: 633, Size: 83 bytes
|
148:
|
High Speed, High RPM, + Major Rain, + Holley Scoop + No Water Seperator ?
(Archive: TD&Q - by Capt Fiero, started: 11-07-2004, last post: 2005-08-18 10:16:44 CEST)
Ok quick details on what happened. Several cars went on a run. Myself and Fire451's car were out in the lead. He developed an electrical problem; car would completely shut down like he had pulled the keys out and turned the ignition off. It was around 11pm on a very cold heavy raining night. ...
Score: 633, Size: 86 bytes
|
149:
|
V6 Tach reads 10% high across the board
(Archive: TD&Q - by Capt Fiero, started: 05-22-2003, last post: 2004-02-23 13:41:30 CET)
We did some road dyno testing on my car and found that my tach reads 10% high across the board. We have pretty much given up trying to figure out why it is high, so I want to find a way to correct it. The only thing we can come up with is the car is an 85GT with an 88GT Tach in it so maybe there...
Score: 633, Size: 52 bytes
|
150:
|
MSD 6 boxes and Stock Ignition Modules
(Archive: TD&Q - by Capt Fiero, started: 02-24-2003, last post: 2003-05-31 09:48:41 CEST)
Has anyone that uses an MSD 6 Seris box ever had an Ignition module or pick-up coil fail. I was talking with a friend and he told me that using an MSD box takes the load off of the factory ignition module and pick-up coil. So it should be good for a long time.I started thinking about it and the...
Score: 633, Size: 51 bytes
|
| |
|
Put a PFF Search Box on your Site!