|
|
151:
|
1984 Fiero SE 2M4 Sudden Idle Spike/Surge
(Technical Discussion & Questions - by Sanhino, started: 01-16-2020, last post: 2020-03-25 04:37:36 CET)
First off I want to say thank you for everyone that's posted before since this a treasure trove of information! I'm 26 and got my Fiero in August and have slowly been picking away at the issues. It's my first project car so it's been a great learning experience so far, however one of the last...
Score: 236, Size: 16539 bytes
|
152:
|
Fabric Shaver
(Technical Discussion & Questions - by David Riedle, started: 03-23-2020, last post: 2020-03-25 03:18:57 CET)
I have been doing a little work on the Indy. The carpets were slightly "shaggy", which often happens with square weave carpets, which the Fiero uses. Years ago I used a "fabric shaver" to spruce up the carpets on a Puma, which is a Brazilian sports car, and thought I would try it on the Indy. Of...
Score: 236, Size: 2080 bytes
|
153:
|
Soldering Dirty Wires
(Technical Discussion & Questions - by Fierology, started: 01-07-2015, last post: 2020-03-25 03:16:18 CET)
I ran into problems when trying to solder corroded connections. I came across this website when terracing what to do, and I thought I would share it with the forum. Looks like a good and simple method of cleaning old wiring connections for...
Score: 236, Size: 7482 bytes
|
154:
|
85 Fiero problem solved !
(Technical Discussion & Questions - by Lou6t4gto, started: 03-05-2020, last post: 2020-03-22 18:27:47 CET)
Been chasing this problem" literally for YEARS". 85 4 cyl / auto . car would Always start and run good, Great low miles car, but every once in awhile just DIE, wait 30 seconds and it would start again. About 6 months ago I installed a" Mechanical fuel Pressure gauge" in the console (so I could...
Score: 149, Size: 17040 bytes
|
155:
|
New to the forum. Questions on 3800 SC install
(Technical Discussion & Questions - by 1flyndo, started: 02-20-2020, last post: 2020-02-24 17:22:45 CET)
First and foremost thank you in advance for the assistance. Purchased a 87 gt with a 5 spd. Engine is gone. Want to swamp a 3800sc. Choice of two. One complete with wiring harness intact and pcm $725 2002 Grand Prix 137k. The other no harness or pcm 2001 Grand Prix 500.Planning to do a...
Score: 149, Size: 10276 bytes
|
156:
|
throttle position sensor replacement
(Technical Discussion & Questions - by Bruce, started: 11-21-2012, last post: 2020-02-09 03:12:06 CET)
As I look at the Chilton instructions,then I look at the throttle body of the V6, it appears that the TPS just unscrews with the two torx screws holding it in place. Am I looking in the right place, that is, opposite the throttle cable, opposite the firewall manifold? It looks pretty easy to...
Score: 299, Size: 9450 bytes
|
157:
|
3400/3500 Swap Information
(General Fiero Chat - by Bridgetown, started: 02-11-2013, last post: 2019-12-24 02:49:36 CET)
In an effort to try to give something back to the forum that I have taken from for many years. I have decided to try to compile as much information as possible into one location regarding the Gen III 3400/3500 (non VVT) swap. So here goes.Firstly, I am in no way an expert on this, or any, engine...
Score: 149, Size: 46385 bytes
|
158:
|
help reading 7730 pin outs from darthfiero
(Technical Discussion & Questions - by Fierokid87, started: 07-16-2014, last post: 2019-12-14 20:23:52 CET)
http://www.cardomain.com/memberpage/430754
Score: 388, Size: 7473 bytes
|
159:
|
Fuel pump relay terminals
(Technical Discussion & Questions - by pmbrunelle, started: 11-24-2019, last post: 2019-11-26 06:44:47 CET)
I'm modifying my wiring harness for my souped up engine, so I want to redo the wiring for the stock fuel pump relay.I've taken a peek inside the relay connector, and visually the terminals appear to be the following:Coil: Metri-Pack 280 unsealedContacts: Metri-Pack 480 unsealedCan anyone confirm my...
Score: 236, Size: 5682 bytes
|
160:
|
Switch to DIS, now the tach is not working
(Technical Discussion & Questions - by Madess, started: 06-21-2018, last post: 2019-10-29 21:41:17 CET)
I switched to Distributor less ignition on my 3.4, I connected the white wire for the tach, but the tach needle doesn't move. The car runs fine, but no tach. I am not using the tach filter. Any thoughts?Thanks for any help.
Score: 236, Size: 3362 bytes
|
| |
|
Put a PFF Search Box on your Site!