|
|
171:
|
WHAT is going on with this car ???!
(Technical Discussion & Questions - by Lou6t4gto, started: 05-09-2018, last post: 2019-07-16 22:17:47 CEST)
1985 Fiero 4 cyl/ auto. car ran Great for Years, past 6 months it been stalling at a light, replaced : Injector, IAC, MAP, O2 sensor,and Temp sensor at fill neck. today, ran perfect, went to fill it up with premium gas (has always run better on premium for some reason), anyway, I get 500 feet from...
Score: 149, Size: 26839 bytes
|
172:
|
Is It Possible ?
(Technical Discussion & Questions - by Lou6t4gto, started: 07-04-2019, last post: 2019-07-07 18:59:31 CEST)
1985 fiero 4 cyl /auto.(50k miles) Every once in awhile the car will "stall" at a light, or NOW even will stall "going down the road" ! I can put it in neutral while "still driving" and hit start and keep on rolling. the Coil "inside the dist" is new, injector is new, fuel pump new,Hose, fuel...
Score: 149, Size: 4683 bytes
|
173:
|
PROM needed for an 84 M19. Prom #'s in thread.
(The Mall - by johnt671, started: 06-21-2019, last post: 2019-06-30 14:47:13 CEST)
Need a PROM for my 84 as shown it subject. #'s said to be compatible are :DDB 0203DDB 3044AMPL 9338Thanks for looking
Score: 149, Size: 1101 bytes
|
174:
|
FS - New Fiero Tachometer Board w/ built in Calibration Circuit
(The Mall - by phonedawgz, started: 07-04-2018, last post: 2019-06-28 08:20:14 CEST)
For Sale - New replacement tachometer boards including a built in calibration circuit. Fix your dead or high reading tach easy.After installing, to calibrate simply power up the tach. Verify the needle indicates zero and if not simply pull the pointer up and off of the shaft. Then reinstall...
Score: 518, Size: 7916 bytes
|
175:
|
Wanted: Pig tails...
(The Mall - by Tony Kania, started: 06-21-2019, last post: 2019-06-27 22:35:30 CEST)
Looking for the pig tail that goes from distributor to coil, and the other side that goes to the loom. I need both that connect to the top of the coil.Pics can be provided if'n necessary. Thanks in advance,Tony[This message has been edited by Tony Kania (edited 06-21-2019).]
Score: 236, Size: 3179 bytes
|
176:
|
Reman ECM relearn ?
(Technical Discussion & Questions - by johnt671, started: 06-20-2019, last post: 2019-06-23 02:03:04 CEST)
Can anyone tell me what the relearn procedure is for the ecm on an 84? I just put a reman in and the idle won't go under 3,000 rpms after two drives. Thanks
Score: 236, Size: 7708 bytes
|
177:
|
No power to ignition
(Technical Discussion & Questions - by Lafiero357, started: 06-21-2019, last post: 2019-06-22 21:00:29 CEST)
I am in need of help . I have an 84 SE auto that was running fine . I was washing it to got to a local block party and when I went to start it the ignition system was dead , no power at all . Everything that works directly off the battery is ok . I checked through the archives and noticed the...
Score: 236, Size: 3002 bytes
|
178:
|
Clip for holding throttle cable on 4.9L swap needed. P/N?
(Technical Discussion & Questions - by Dennis LaGrua, started: 05-11-2019, last post: 2019-05-15 21:09:36 CEST)
My 4.9L swap is finally finished was started today and it sounds awesome. Time to make a custom throttle bracket and adapt the Fiero V6 throttle cable. I just need to find the clip that holds the throttle cable to the throttle body pulley. When I bought that 61K mile powertrain, the clip was...
Score: 236, Size: 4995 bytes
|
179:
|
Trying to get 86 Fiero started
(Technical Discussion & Questions - by Blitz54, started: 06-18-2017, last post: 2019-05-14 01:33:09 CEST)
Hello peeps. I had made a post when I first got my fiero, but I figured I'd make a new topic now that I am actually working on the car. Here's the issue. Car was supposedly running when parked. It sat for two years. Now the car turns over, but won't start. If you let it sit for 10 minutes, it will...
Score: 149, Size: 69259 bytes
|
180:
|
87 2.5L Iron Duke OBDI ALDL Scanner
(Technical Discussion & Questions - by Robodog_X920, started: 04-21-2019, last post: 2019-04-25 07:49:42 CEST)
Hello. I am trying to figure out if there is a 1987 2.5L Iron Duke OBDI ALDL scanner out there. I know phonedawgz had one for the 84-86, but I am unsure if he had one for an 87. As far as I know, nothing has come up. Let me know if anyone has any leads.
Score: 149, Size: 1773 bytes
|
| |
|
Put a PFF Search Box on your Site!