|
|
131:
|
2.8 high idle
(Technical Discussion & Questions - by pontiacfierokid1985, started: 05-06-2020, last post: 2020-05-10 20:31:05 CEST)
So I’m having a high idle of 1300-1500 86 2.8 4 speed. I’m trying to get a custom chip made where they can lower the idle counts down so I can have a idle of 1000 rpm I been trying to get the idle down to 1000 using ogre cave trick and it’s not working can someone make a chip for this or nah...
Score: 149, Size: 2545 bytes
|
132:
|
Car issues again
(Technical Discussion & Questions - by Monkeybean007, started: 03-23-2020, last post: 2020-05-06 21:14:19 CEST)
85 gt v6 2.8l -- My car runs amazing when I first start it up and start driving but when the car warms up it starts to random misfire, and I get low acceleration and power under load . I've replaced some stuff so far -o2 sensor-tps-alternator-new spark plugs-new spark plug wires- fuel filter-fuel...
Score: 420, Size: 49823 bytes
|
133:
|
1988 GT EGR Solenoid Shot
(Technical Discussion & Questions - by Forrest, started: 04-30-2020, last post: 2020-05-02 11:22:23 CEST)
Hey guys...so my sons 88gt is guzzling gas. The car runs solid but he has only been get 12-13 mpg. He deals with it because he loves the car but I knew something wasn't right. I went through all the vacuum lines and found a few leaks. Fixed them...car ran a little better and the cruise control...
Score: 347, Size: 14912 bytes
|
134:
|
4.9 parts
(The Mall - by treborerellim, started: 04-28-2020, last post: 2020-05-01 19:21:10 CEST)
Does anybody still make plug-and-play wiring harnesses for a 4.9 with a 4T60 Fiero transplant. I'm not particularly well-versed in the electronic age. More a carb distributor man. Any help would be appreciated.Bob Miller
Score: 149, Size: 3851 bytes
|
135:
|
Dash lights will not turn on.
(Technical Discussion & Questions - by rbell2915, started: 04-26-2020, last post: 2020-04-30 08:18:19 CEST)
I disconnected the transistor and jumped C&D and still nothing is working. Ran out of fuses so I need to go buy some more. I don't understand what the issue is. The lights were working great, then all of a sudden they weren't.
Score: 149, Size: 7361 bytes
|
136:
|
1988 2.5 ECM wiring
(Technical Discussion & Questions - by Firezappy, started: 04-24-2020, last post: 2020-04-25 17:46:08 CEST)
Hello, I cannot for the life of me get a good connection with my wiring to the ecm. I have at this point soldered some wires directly to the pcb, and still even just to much vibration makes the other wiring lose connection. You so much as touch it and bam, the engine stops because the fuel pump...
Score: 149, Size: 3512 bytes
|
137:
|
OBD1 to OBD2 adapters
(Technical Discussion & Questions - by sjmaye, started: 04-18-2020, last post: 2020-04-19 16:10:11 CEST)
I have seen obd1 to obd2 conversion cables on Amazon. I am interested in them mainly because I already have a OBD2 bluetooth scanning scan tool. Does anyone here have experience with these?
Score: 299, Size: 6024 bytes
|
138:
|
New Fuel Pump not working at all
(Technical Discussion & Questions - by TheDuke, started: 04-07-2020, last post: 2020-04-10 23:37:46 CEST)
dropped the tank installed new pump with new sock and new pulsator, filter, relay, fuse, put it all back in with 5 gallons of gas and..............nothing. Anyone got any ideas?
Score: 236, Size: 24293 bytes
|
139:
|
TEMP GAUGE NOT WORKING
(Technical Discussion & Questions - by michael jatcko, started: 04-09-2020, last post: 2020-04-10 17:39:57 CEST)
86 v6 motor dash gauge don't work. what I did to check by the manual, grounded wire from sending unit to dash, goes to hot.gauge and wiring to gauge good. checked sending with ohm meter, no reading from ether prong to ground.. got resistance from prong to prong.. had good sending unit base...
Score: 236, Size: 5168 bytes
|
140:
|
3800SC THROTTLE BODY
(Technical Discussion & Questions - by Spoon, started: 04-09-2020, last post: 2020-04-10 03:52:05 CEST)
Hoping somebody will step up to the plate with some info. While removing the IAC, TPS and MAF sensors one of the torx security screws snapped off on the IAC. This is a 2000 engine and I believe this sensor is original. I took a good screw to Home Depot and it matched up with a metric M4-0.7x12MM....
Score: 149, Size: 1880 bytes
|
| |
|
Put a PFF Search Box on your Site!